AutoMycoNo-wire install Beta
Installs AutoMyco over Bluetooth, straight from this page. Nothing to open up and no adapter needed.
All install options. Want a backup first? Use the wired install.
Sign in first so the installer can fetch the firmware.
Sign inBefore you start
This is new. It hasn't been tried on many chambers yet. If it fails part-way, your chamber keeps running the stock firmware, and the wired install always works.
- Use Chrome or Edge on a computer, or Chrome on an Android phone, within a few metres of the chamber. On an iPhone, use the iPhone app instead.
- Keep the chamber plugged in for the whole install, about 5 minutes.
- Keep this page open and your screen on until it's done.
Put the chamber in setup mode
Hold the button on the back of the chamber for about 3 seconds, then let go. It starts advertising over Bluetooth for 5 minutes. Then click Find my chamber and pick it from the list.
Install
All set
- The chamber restarts into AutoMyco and joins the Wi-Fi it was using before. Give it a minute.
- Open the chamber in the iPhone app, Home Assistant, or its own control page. In Home Assistant, add it within 30 minutes of it starting up.
- Wasn't on Wi-Fi before, or not showing up after a couple of minutes? Give it Wi-Fi over Bluetooth from the Home Assistant app, or improv-wifi.com in Chrome. When it asks you to authorize, press the button on the back of the chamber once, briefly (don't hold it: a 5-second hold starts the self-test). Do it within 30 minutes of the chamber starting up; after that, unplug it for 10 seconds first.
Still not on your Wi-Fi? It probably has no network yet: either it was never set up in the Terrashroom app, or that network has changed. Open improv-wifi.com in Chrome (or the Home Assistant app), pick the chamber, and when it asks you to authorize, press the button on the back once, briefly. Then enter your Wi-Fi name and password. More than 30 minutes since it started? Unplug it for 10 seconds first.
Stuck? See Help, or use the wired install.